Skip to content

003 - DaVinci Resolve

Important DaVinci Resolve Information

DaVinci Resolve connects with the HUI protocol and controls a maximum of eight channel strips. Buttons not listed below are not assigned in Resolve, and V-Control Pro shows "Button not assigned to Resolve" when you press one. See DaVinci Resolve for setup.

Channel Strips
Fader Controls the track's fader level.
Mute Mutes the track.
Solo Solos the track. Double-press to select or deselect the track.
Select Selects the track. The green LED shows the track is selected.
Rec Switches the Select buttons to record-enable tracks. Press again to return to selecting tracks. The red LED shows the track is record-enabled. Record-enable works only when an input is patched to the track.
Knob Adjusts the track's pan.
Command + Knob Fine pan adjustment.
Track Meters Displays track metering.
Displays
Upper Scribble Strip Shows the knob (pan) value.
Lower Scribble Strip Shows the track name.
Display Mode Toggles the lower scribble strip between the track name and the fader level.
Automation
Read Turns automation on.
Off Turns automation off.
Write Sets automation to Write mode.
Touch Sets automation to Touch mode.
Latch Sets automation to Latch mode.
Console View B + EQ Sets automation to Trim mode. In Console View B, the Channel View buttons also set the other automation modes, and the scribble strips show each button's mode.
Transport
Play Starts playback. Double-press to play again.
Stop Stops playback. Double-press to move the playhead Home.
Record Press Record + Play to begin recording. One or more tracks must be record-enabled.
Rewind Moves the playhead backward.
Fast Forward Moves the playhead forward.
RTZ Moves the playhead to the start.
Option + RTZ Moves the playhead to the end.
Wheel Jogs the playhead.
Navigation
The arrow buttons operate in three modes. Bank mode is the default.
Bank Left/Right bank eight channels. Double-press Left to go Home (track 1). Double-press Right to go to the Master channel strips. Press Bank again for cursor mode.
Nudge Left/Right move one channel. Press Nudge again for cursor mode.
Cursor mode Up/Down/Left/Right move the selection.
Zoom Switches the arrow buttons to horizontal and vertical zoom.
Utility
Undo Undoes the last edit. Option + Undo redoes.
Save Saves the project.
Enter Acts as the Enter key.
ESC Acts as the Escape key (Console View A).