Skip to content

D-Command - DaVinci Resolve

Important DaVinci Resolve Information

DaVinci Resolve connects with the HUI protocol and controls a maximum of eight channel strips. The D-Command main unit controls strips 1-8. D-Command Fader Modules are not supported with Resolve. Buttons not listed below are not assigned in Resolve, and V-Control Pro shows "Button not assigned to Resolve" when you press one. See DaVinci Resolve for setup.

Channel Strips
Fader Controls the track's fader level.
Mute Mutes the track.
Solo Solos the track. Double-press to select or deselect the track.
Select Selects the track.
Record Record-enables the track. Works only when an input is patched to the track.
Knob Adjusts the track's pan.
Automation LEDs Show the track's automation mode.
Track Meters Displays track metering.
Displays
Upper Scribble Strip Shows the knob (pan) value.
Lower Scribble Strip Shows the track name.
Transport
Play Starts playback. Double-press to play again.
Stop Stops playback. Double-press to move the playhead Home.
Record Press Record + Play to begin recording. One or more tracks must be record-enabled.
Rewind Moves the playhead backward.
Fast Forward Moves the playhead forward.
RTZ Moves the playhead to the start.
GTE Moves the playhead to the end.
Scrub Press Scrub and turn the wheel to jog the playhead.
Shuttle Press Shuttle and turn the wheel to shuttle the playhead.
Automation
Read Turns automation on.
Off Turns automation off.
Write Sets automation to Write mode.
Touch Sets automation to Touch mode.
Latch Sets automation to Latch mode.
Trim Sets automation to Trim mode.
Navigation
Bank Left Banks eight channels left. Double-press to go Home (track 1).
Bank Right Banks eight channels right. Double-press to go to the Master channel strips.
Nudge Left/Right Moves one channel left or right.
Up/Down/Left/Right Move the selection.
Zoom Switches the arrow buttons to horizontal and vertical zoom.